Leak testing solutions
Project overview
Click on the pictures for more information.
Hard vacuum test – steel drums.
For this specific project, the Hard vacuum test was used. The hard vacuum test (using helium as tracer gas) is the most precise method to automatically leak test a product (up to 10-8 mbar*l/s). This test can be performed with active helium supply or with products that are pre-filled with helium.
Pressure decay test – OH steel drums.
Our in-line leak testing systems are designed for extremely accurate leak testing for a wide variety of drums and similar products. It`s smart design provides a fully automatic solution with a high capacity rate that can be implemented to provide a zero defects production output.
Pressure decay test – tight head steel drums.
Our fully automatic pressure difference (DP) tester for tight head steel drums is easy to modify to the required throughput capacity. It’s modular design also allows the system to be easily upgraded in the future.
Hydrostatic Test - IBC Containers.
This hydrotester for IBC containers stands out due to its compact size and rapid testing process. With the capability to perform a pressure test, an IBC container can be thoroughly examined for potential leaks. This setup provides an efficient and precise method to ensure the integrity of the containers, with a remarkably short testing period.
Helium accumulation leak tester – gas valves.
This standardised machine is designed to leak test smaller products in-line. By using the Helium accumulation testing method, this machine can reach precision levels up to <2.0*10-5 [mbar*L/sec]. With the ability to test 2 products at the same time, the machine is able to reach a high test capacity level.
Pressure decay test – valve tester + calibrator.
This standardised machine is designed to semi-automatically leak test valves (or similar products), with also a calibration option included. The compact device is meant to be placed on a desk/production table, products can be placed in the device manually for testing.
Bubble/submersion leak test – steel drums.
With our Submersion tester for tight head steel drums, an operator is able to easily perform a leak test on a produced or reconditioned steel drum. The tester is made to automatically push the drum under water, and keep it there while the operator performs the analysis.
Bubble / submersion leak test – custom made.
Verborg engineering B.V. has the ability to create Submersion testers for your specific product by using several standardised solutions. We are very experienced in designing / creating leak testers which are applicable for a wide variation of products in the same category. With these aspects in mind, we strive to make a solution with the most efficiency and versatility for your production line.